Custom oval duct transition fitting / hose-shaped reducer

Generate a new model based on your own parameters.

General instructions

On both sides, the width (parameters #1 and #4) must be strictly greater than the height (parameters #2 and #5). Example: width = 90.1 mm, height = 90 mm.

Form

illustration of the parameters oval duct transition fitting / hose-shaped reducer

#1 side A internal width * (mm)

10 to 300 – up to 1 decimal place

#2 side A internal height * (mm)

10 to 300 – up to 1 decimal place

#3 sleeve length on side A * (mm)

5 to 100 – up to 1 decimal place

#4 side B internal width * (mm)

10 to 300 – up to 1 decimal place

#5 side B internal height * (mm)

10 to 300 – up to 1 decimal place

#6 sleeve length on side B * (mm)

5 to 100 – up to 1 decimal place

#7 thickness * (mm)

1 to 8 - integer

#8 transition length * (mm)

20 to 300 – up to 1 decimal place

#9 Y offset * (mm)

0 to 300 – up to 1 decimal place

#10 Z offset * (mm)

0 to 300 – up to 1 decimal place

#11 end chamfers *

none

inside

outside

The model will be generated with the following characteristics:

License ITE IPU v1.0 - Iteration3d (Internal and private use, non-commercial – no distribution – no derivatives)

Format: STL Free