Custom inline tube adapter

Generate a new model based on your own parameters.

General instructions

The diameter on side A (parameter #2) must be strictly greater than that of side B (parameter #5).

Form

illustration of the parameters inline tube adapter

Notes:

The transition refers to the connection interface between the two tubes. It defines the total length of the adapter, which is equal to the sum of the tube lengths plus the length of the transition.

#1 side A length * (mm)

5 to 300 – integer

#2 side A outer diameter * (mm)

5 to 300 – integer

#3 side A thickness * (mm)

1 to 20 - up to 1 decimal place

#4 side B length * (mm)

5 to 300 – integer

#5 side B outer diameter * (mm)

5 to 300 – integer

#6 side B thickness * (mm)

1 to 20 - up to 1 decimal place

#7 transition length * (mm)

5 to 300 – integer

#8 axis offset * (mm)

0 to 300 – up to 1 decimal place

#9 ends fillet *

no fillet

fillet on the outside

fillet on the inside

fillet on both inside and outside

The model will be generated with the following characteristics:

License CC BY - Creative commons (attribution - commercial use allowed)

Format: STL Free

Home	/Inline tube adapter
	/On demand 3D model builder