Custom multi compartment storage box

General instructions

It is essential that the value of compartment fillet (radius) (parameter #7) be strictly less than half the length (#3) and width (#4) of the compartments. If the entered value is incorrect, the generation engine will notify you.

Adding fillets inside the compartments increases the file size.
Why? What defines the 3D STL file format?

Form

illustration of the parameters multi compartment storage box

Notes:

The height of the compartments corresponds to their depth.

Parameter #7 compartment fillet (radius) applies to the base and sides of the compartments, not the top edges.

To get the total height of the box, apply the formula: coH + waT

#1 number of raws *

From 1 to 20

#2 number of columns *

From 1 to 20

#3 compartment length * (mm)

Range: 2 to 100 – 1 decimal place

#4 compartment width * (mm)

Range: 2 to 100 – 1 decimal place

#5 compartment height * (mm)

Range: 2 to 100 – 1 decimal place

#6 wall thickness * (mm)

Range: 2 to 10 – 1 decimal place

#7 compartment fillet (radius) * (mm)

Range: 0 to 49.9 – 1 decimal place

The model will be generated with the following characteristics:

License CC BY - Creative commons (attribution - commercial use allowed)

Format: STL